Grab some G54 merch here –
In this episode we try a bunch of stuff to repair an engine on the cheap – that actually works!
Our instagram
Likes: 2447
Views: 36480
Leave a Reply
Comments are closed.
Grab some G54 merch here –
In this episode we try a bunch of stuff to repair an engine on the cheap – that actually works!
Our instagram
Likes: 2447
Views: 36480
Comments are closed.
Do you remember time when Lada was valuable and definitely not a toy in any kind.
ehh thats actually how i did my head gasket on my Caldina Turbo. it worked
CAN YOU TRY IF IT WORKS WELDING THE PISTONS. (ALuminum/iron, forged/nonforged)
I have actually seen a shop in the Appalachian Mountains where a guy had a grinding set very much like that. He said that he had worked heads, flywheels, & pumps on anything from a Massey Ferguson to a Big Block Mopar.
Better than factory
Now that's a HIGH TQ starter!
I have an idea, probably a rather difficult one but I could see it working, glass pistons
Cast iron would work for rings, steal doesn't have enough spring
should of just poured a little oil in each cylinder itll give it enough compression to start. 60 psi is about all youd need
Piston ring gap is way too big because the disc cutting is too thick, hope they keep trying.