Replacing The Liner In A MIG GUN – On A MIG Welder – DO IT YOURSELF
This is a detailed video from start to finish on replacing that old worn out MIG Gun liner on your MIG Welder! It’s easy and simple and saves alot of money doing it yourself. How to save money and do the job at home in your garage! Miller, Lincoln, Hobart, or any other MIG Welder — These instructions apply to any and all Welders of this type.
#Welder #HowTo #MIGWelder
or 972-420-1293
@My Friend PETE
@Pete’s Guitars And More
Radnor Liner:
Miller Welders:
Likes: 307
Views: 4163
Thank you very helpful 😊
A new liner, tip and nozzle plus you know the condition of shield gas o-rings. It don’t get any better than that for the next 20 years. Ed402 of the North.
y2kxj, You are right. Mine takes the 14” spools & had to make adaptor to get the smalls to fit. I keep extra wire in zip-lock bags so the don’t get a rust film on them. If not needing the welder. High humidity is hard on every thing. Have a great 4th “y2kxj” !
Great video well done Thank you for sharing.
Don't forget to turn the wire speed back Down… Great Vid Pete ! WelderX
Thanks for the tip 👍!!
Too much lube it slipped out of my hand
unravel
Why use .035 liner when you’re using .023 MIG wire? Why not use a .023 liner?
Cool vid. I just need to get a mig welder. What brand would you buy today my friend pete???? Diy, homeowner model? Thx
Just curious, hope I can ask. 1. Wheres the CLOWN CLOCK? 2. Where are the car rear ends you use for couches? Havent seen them in your Moab videos. Thx