In this video i walk you thru the steps i take to repair this ford f150 tailgate.
how to from start to finish!

how to properly block a dent

If this video has been helpful please LIKE AND SUBSCRIBE TO HELP THE CHANNEL.

BE SURE TO CHECK OUT MY OTHER HOW TO VIDEOS!
⬇️⬇️⬇️⬇️⬇️⬇️⬇️⬇️⬇️⬇️⬇️⬇️⬇️
how to use body filler to repair a dent

How to repair and paint your bumper

How to remove fisheyes from your paint job!

How to save a bad paint job

Due to factors beyond the control of Garage Noise, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. Garage Noise assumes no liability for any property or personal damage that may arise from doing a repair on your vehicle after watching any of my repair video’s. Due to factors beyond the control of Garage Noise, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Again Any injury, damage or loss that may result from improper use of tools, equipment, or the information contained in this video is the sole responsibility of the user and not Garage No

Likes: 46

Views: 2046

Leave a Reply

  1. Alexis Rodriguez

    great i learn a lot thank you

  2. DrivewayAutoBody

    Awesome.
    I have a stud welder (harborfreight) it is nice but the slide hammer is garbage.
    Is there one you recommend?
    And where can I get the slide hammer you used in the video?
    Thanks

Comments are closed.