[bsa_pro_ad_space id=14]
My Friend Pete shows us an easy and simple way to repair a bad door edge on a car or truck without replacing the whole door skin. It’s fast easy and simple when you know how to do it right! How To and DIY is the name of the game here!
or 972-420-1293
#Welding #CarRestoration #DiyAutoSchool
[bsa_pro_ad_space id=15]
Likes: 317
Views: 3236
I'm lucky. There are no parts for 1970 Cyclones. So I had to hand-fabricate entire sections.
I noticed that the wire was out farther than normal. Was that so you could support your hands and have a steady weld or is this just the way you do it.
Just noticed you have over 100 thousand in this channel,wonder if people know about ""SWRNC Pete"" channel.
Hey Pete did you finish out the area of the door with primmer or filler or both?
Pete thank forcthe vid man you dont know the problem that i had whith a doir edge and know i learnd thanks pete
I like your videos, they are very explanatory. Even though I dont do body work, I learn from you. Thanks for sharing your knowledge.
Good job Pete, love metal when it comes to repair. I worked with fiberglass folks for years and the turn around is days
I just got a welder ⚡️???⚡️ Klutch 140i from northern tool, I’m below $500 after welder, gas bottle, wire etc. its amazing vs flux core ⚡️???⚡️
That's the worst welding iv ever seen you do..like you dont even care about what your welding or yourself…no gloves and probably no other ppe. Amateur hour
That gringer is not a variable speed grinder. Dont be dumb Pete. It's just not a variable speed grinder.