Transmission removal, replacement, and installation. Learn how to remove a transmission so you can replace your clutch or flywheel, or so you can rebuild your transmission and install a new one in your car or truck.
In this video I show you the 10 simple steps on how to replace a transmission. I am doing this on a rear wheel drive 98 Mustang but the process is very similar on other rear wheel drive, front wheel drive, and even automatic cars and trucks. Each detailed step will allow you to learn how to remove a transmission yourself so you can replace a clutch, flywheel, rear main seal, throw out bearing, pilot bearing, or just swap transmissions.
Transmission Removal Checklist Download (FREE):
How to Replace a Clutch and Flywheel:
Transmission Jack:
12 Ton Jack Stands:
Ramps:
Dust Mask:
Dust Filters:
Flex-Head Ratchet:
Torque Wrench:
Extendable Ratchet:
Ratcheting Wrench Set:
→ Become a ChrisFix Subscriber:
→ Instagram:
→ Facebook:
→ Website:
→ My Channel Home Page:
**If the video was helpful, remember to give it a “thumbs up” and consider subscribing. New videos every Week**
Disclaimer:
Due to factors beyond the control of ChrisFix, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFix assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFix recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFix, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFix.
Likes: 129875
Views: 4969295
Can you show how to change a front bumper
I had to come watch this video again to make sure im supporting the engine right 😂 thanks again chris
Been looking at this because my reverse in my 3 series just sometimes doesn't get into gear, about 15% of the time. I doubt it will be this easy due to it being an automatic, but who knows…
Also i also wonder if it would be possible to put an M3 transmission instead (automatic as well).
20:25 Man u obsessed with hentai smhh
harbor freight sells that exact same transmission jack for $80 less
By the way, anyone who has worked on a B-2A Stealth Bomber has calibrated their elbow to 70lbs ft torque. LMAO
that door transition from the shifter to the exhaust was CLEEEEAAAAN 😭
Hi, I'm a Chris too, I have a volkswagen touran 2012 1.4 tsi, I'm leaking transmission oil, and sometimes smell oil or something to that extent, I'm also seeing a a blinking D7 and spanner showing up… Can you help or anyone out there?
You should also do this for FWD cars. RWD manuals are the easiest transmissions to take out
Chris you are the beast 💪💪👍