Rebel Editor May 26, 2022 28 Comments



Bad wheel bearing? Wheel bearing noise? Learn how to replace a wheel bearing in your car or truck. In this video I show you how to replace a front or rear wheel bearing hub assembly. With this wheel bearing replacement you need to remove the axle nut, the brake caliper and rotor, and unbolt the bad wheel hub bearing assembly. It is that simple! I show you how to replace the wheel bearing at home using common hand tools, and this time the video is an ASMR (autonomous sensory meridian response) video with high quality audio!

Tools and Products:
Torque Wrench:
Wheel Bearing:
Slide Hammer (you can rent for free from parts store):
Flex Ratchet:
Threadlocker:

→ As an Amazon Associate I earn from qualifying purchases.
→ Become a ChrisFix Subscriber:
→ Instagram:
→ Facebook:
→ Website:
→ My Channel Home Page:

**If the video was helpful, remember to give it a “thumbs up” and consider subscribing.**

Disclaimer:
Due to factors beyond the control of ChrisFix, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFix assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFix recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFix, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFix.

Likes: 76689

Views: 1784336

Leave a Reply

  1. Tsf Hyp4r

    Just noticed Chris has so muscles 😳😩

  2. Jesse Hays

    Hey, I know this video is like, a year old, but is it possible if you could do a video on the replacement of C/V joints?

  3. not you

    Bwahahahaha anyways I have to thank you for all the knowledge you have dropped over time for us all. I've done plenty of DIY car maintenance and repair with a kudos to you for the crash course

  4. obed cuffy

    I wish this dude lived in my country 🥲🥲

  5. Alakablam

    As a guy who loves working on cars, this is just what I needed. 👍🏻

  6. Big D Fitness

    Why have I not thought about taking the brake caliper, rotor and pads off as an assembly?? Definitely easier than taking each part off.

  7. Avenue X at Cicero

    Does that white marker pen have a specific name?

  8. Brynton Drewett

    Should definitely do a part 2 to This. But move talking

Comments are closed.