Now you can RENEW even Maintenance Free Batteries and save huge!!! Hoolio’s Tools Below
just Click More Below

This Video here is for all maintenance batteries

TOOLS:

Best Spray Bottles
Best Headlamp
Small Screwdriver Set

Welder for Deep Cycle ONLY 6 Volt & 12V Batteries or

Use This for all Standard 12-volt Batteries
**If the above welder is unavailable, either one of these will work or **

After doing this process use this charger to slowly and fully charge the battery

The small compensation we receive from these amazon links helps to keep our channel
available to you for free.

*****Disclaimer*****

Due to factors beyond the control of SWEET PROJECT CARS, we cannot guarantee against the improper use or unauthorized modifications of this information. Make sure you check with your manufacturer to make sure this will not affect your factory warranty. SWEET PROJECT CARS assumes no liability for property damage or injury incurred as a result of any of the information contained in these videos. Use this information at your own risk. SWEET PROJECT CARS recommends safe practices when working with tools seen or implied in our video and written content. Due to factors beyond the control of SWEET PROJECT CARS, no information contained on this YouTube channel shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this content is the sole responsibility of the user and not SWEET PROJECT CARS.

Likes: 665

Views: 11866

Leave a Reply

  1. Marco Street

    Great information. You said you turned up the welder to 50. Fifty wha5? amps?

  2. 462ANIMAL

    All I have is a Lincoln 220v arc welder. Hmmm lol

  3. mark ellis

    Does this work on a battery that is completely dead?

  4. Genghis Chuan

    I have a 200 amp charger really good one its this one Associated Equipment US20 6/12 Volt works good

  5. SEYMOUR SCAGNETTI

    Excellent video. And, it is ALWAYS a good day when we hear from Hoolio!

  6. Craig Yoch

    So awesome. I do not have a welder but would a battery charger work in the highest setting (engine start)? If so, should I go longer than 5 minutes with 10 min rest periods in between?

Comments are closed.