Now you can RENEW even Maintenance Free Batteries and save huge!!! Hoolio’s Tools Below
just Click More Below
This Video here is for all maintenance batteries
TOOLS:
Best Spray Bottles
Best Headlamp
Small Screwdriver Set
Welder for Deep Cycle ONLY 6 Volt & 12V Batteries or
Use This for all Standard 12-volt Batteries
**If the above welder is unavailable, either one of these will work or **
After doing this process use this charger to slowly and fully charge the battery
The small compensation we receive from these amazon links helps to keep our channel
available to you for free.
*****Disclaimer*****
Due to factors beyond the control of SWEET PROJECT CARS, we cannot guarantee against the improper use or unauthorized modifications of this information. Make sure you check with your manufacturer to make sure this will not affect your factory warranty. SWEET PROJECT CARS assumes no liability for property damage or injury incurred as a result of any of the information contained in these videos. Use this information at your own risk. SWEET PROJECT CARS recommends safe practices when working with tools seen or implied in our video and written content. Due to factors beyond the control of SWEET PROJECT CARS, no information contained on this YouTube channel shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this content is the sole responsibility of the user and not SWEET PROJECT CARS.
Likes: 665
Views: 11866
Will this work with a MIG welder?
cool
I remember de-gassing lead acid batteries back in HS in auto shop (that's what we called it). I never knew the maintenance-free batteries could be opened up like that. Thanks. 👍
Didn't you do this before?
Someone did.
Long time ago.
Excellent advice, Hoss! Two things I always do is get the top of the battery spanking clean so there is no conduction between the posts and I always wear safety glasses. I have seen two instances of a spark blowing the top off batteries! No matter how careful you are, sometimes things happen — no bueno. By the way, when are you going to trot out that tool and parts magician, Jose Rodregez Chavez Jorge Clint Eastwood? We would all like to see your famous sidekick.
Does it need to be a modern switchmode welder? Can I use an older mains frequency (larger heavier coil) type stick welder?
I have a Hobart transformer type welder. Will it work for this, or is it necessary to use an inverter type, like you show in the "tools" section?
Hey Mike. I finally had the chance to do this for the first time, a few weeks ago. Because my own batteries are AGM's I had to wait for a dead lead acid battery. My father-in-law's one died and I used your method. And it works again. It's a great tip. Have a great week. Dutch regards, Nico.
I've looked cheapest I've found is 120 I need to try it on my big cat batteries to replace them it costs 140 $ I've got 4 of them
Are you using ac ,dc positive, or dc negative on the welder. Mine has all 3.