[bsa_pro_ad_space id=14]
Rust hole removal and repair. Repairing a rust hole in your car is something that should be done quickly to prevent it from spreading. You can easily do this at home with some practice and get the results you see in this video. I teach you the basics of what welder you want to use and how to weld so you can get started. I answer questions like, should you butt weld or lap weld floor panels? Rust is common at the wheel wells, quarter panels, rocker panels, and floor boards of cars and in this video I show the proper and most thorough way to remove and repair rust.
Buying this car for $300:
Rust Repair WITHOUT a Welder:
PRODUCTS:
Cheap Flux Core Welder:
Cheap MIG Gas Welder:
Welder I Used:
Vent Tubing:
Blower Fan:
Full Face Respirator w/ Filters:
TURBO KIT:
Rust Paint:
Sheet Metal Nibbler:
Angle Grinder:
Wire Wheel:
Digital Caliper:
Socket Set:
→ As an Amazon Associate I earn from qualifying purchases.
→ Become a ChrisFix Subscriber:
→ Instagram:
→ Facebook:
→ Website:
→ My Channel Home Page:
**If the video was helpful, remember to give it a “thumbs up” and consider subscribing.**
Disclaimer:
Due to factors beyond the control of ChrisFix, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFix assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFix recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFix, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFix.
[bsa_pro_ad_space id=15]
Likes: 115477
Views: 3055583
How did you get the video view of what you see through the face shield?
What your not going to tidy up the welds?
Google says copper is too weakly magnetic to hold a patch piece in place.
The tools and the fixing jobs are university’s degree kind of level. I am at primary school level only.
Why did i just see a kill switch
😂😂😂😂😂😂😂😂😂😂
Is this the same paint you would use on surface rust on a truck frame? That looks super simple to clean a truck up
I wan to see the turbo DIY
where did you buy the seal for the top mine is leaking as well the only place that has them are like advanced auto parts and they are like $300