Need new brake pads and rotors? Learn how to replace your brakes yourself and save more than half the cost of a shop! I show you every step including how to remove and install pads and rotors, where to use brake grease, how to grease the guide pins, and how to torque the bolts for a safe and complete brake job.
Find your car’s repair manual:
Brake Pads and Rotors:
Brake Compressor Tool:
The Socket Set I use:
Here is the Silicone Paste I used:
Torque wrench I use:
3 Ton Jack:
Breaker Bar:
Caliper Guide Pin Video:
Truck Brake Pad and Rotor Replacement Video:
Drum Brake Replacement Video:
Become a ChrisFix Subscriber→
Instagram→
Facebook→
Website →
My Channel Home Page →
**If the video was helpful, remember to give it a “thumbs up” and consider subscribing. New videos every Thursday**
Disclaimer:
Due to factors beyond the control of ChrisFix, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFix assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFix recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFix, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFix.
Likes: 82292
Views: 5856800
How do you turn the steering wheel when the car is off? It wouldn’t have power steering. It’s a genuine question
the ear of the front brake hardware needs to be tucked in the ring of the wear indicator so the brake pad will be lifted off the rotor after braking, or it will cause drag.
Can you use power tools?
Should I pull the parking brake before changing pads, or release it?
💂♀️⚓📡question i ask,should ur emer handbrake lever be down when changin both front& rear dic pad ??👀🏴☠️
Hi Christ, you forget to tell people to pump the brake for the first time whent the brake change is done. I really appriciate your show. Thanks
Another Great Video!
Chris, how do you know that two bolts are 98 pound feet?
Make sure you pump your breaks afterwards! You could of compressed your breaks to much and you need it to fit against your new break pads again
Thank you for your time and knowledge the best walk through step by step video I've ever seen great and wonderful job bro thanks again