[bsa_pro_ad_space id=14]
Welp.. today we wanted to install the wide fenders, but we found some rust.. SO we are going to repair it properly instead of using more bondo! This will definitely last longer than bondo as far as a DIY Rust Repair!
Downforce on a FWD:
THE COMMITTED CREW:
FOLLOW ME HERE⬇️
•Instagram –
•Facebook –
•Twitter –
SEND STUFF HERE?
PO Box 57359 Coquitlam, BC, V3K 0C9
CURRENT GEAR:
Main Camera
Vlog Camera
Lens
Mic
Best Camera Bag
Tri-pod
Gorilla Pod
Music:
[bsa_pro_ad_space id=15]
Likes: 3095
Views: 45658
Fuck what you guys are talking about with his car , what flavor Cheetos were those?
an exhaust fan yes
I had the dust problem what I did was ran ducting down outside after the window threw a watter bath for a filter it works grate and no dust outside all the cleanup is cleen the top of the water after each job
you could use a welding air contorl arm thats what i used in welding class. use this https://weldingsupply.com/cgi-bin/einstein.pl?PNUM::1:UNDEF:X:K1655-12 . Then get a square vent for the hole in your wall https://www.famcomfg.com/product/square-to-round-transition-box-2/?gclid=Cj0KCQjwu-HoBRD5ARIsAPIPencXcLkM1GXpaE_phO5EgbI9eEcnejlXFrwwwvVchCKomoUcLtAb1FgaAgE7EALw_wcB (:
When you weld sheet metal you have to tack it on one side then move to the other dont do beeds just keep tacking back and forth then grind it down and it wont warp
Hatch better be spoon yellow and blue ?
I wish I had a friend like Emerson
Should weld tabs onto the dips and pull them out with pliers and then just snap the tab off
why are you are using a 2×2 metal plate you can buy weld in pieces for the rear fenders they here in the netherlands 55 euros
Civic Squad