Hi this is Part one of 1000 in our series on repairing the rust on a vintage Gmc van. In this video I will be showing how I fabricate rocker panels using simple techniques and tools that are available to the average hobbyist.
#rust #vanlife #restoration #autobody #chevyvan
If you found this video useful and would like to help support the channel, please check us out on patreon.
Also please check out some other great channels I watch
@coldwarmotors
@RandahlR-Shedbythetracks
@Mart’s Garage
@RAC GARAGE
@LGKustoms
@The Old Parakao Store Cafe/Bar
@asciimation
@DD Speed Shop
@Halfass Kustoms
@Make It Kustom
@Wild West Garage
Likes: 1521
Views: 30269
Thanks! I'm already feeling like collapsing onto the floor and just staring at the ceiling for 30 minutes contemplating how much work there is to do and how it will never get done!
I know it's not popular: I had to stop watching, because the pain was too real, haha! Looking forward to the hard-earned turn-around! Cheers!
Just subscribed at the suggestion of the wonderful folks over at Cold War Motors. Looking forward to watching some of your videos!
Awesome process & work. Thank you.
LMFAO ;0)
My Old Boss used to say ,The hardest part of any job is picking up the tools to get started.
Watching this again but Stoned, Its even a better after a Bong.
Nothing a little expanding foam,duct tape and a coat of cement and done,like factory.🙉🙉🙉
Carter is a beast. I'm over here wringing my hands over a silver dollar sized hole in my cab corner and this man is reconstructing a whole van from scratch with basic tools. my hat is off to you sir!
I'm doing a 62 belvedere right now.. and if i think too much i panic about how much work it is… i start at the back of the car and work forward one bite at a time… 🙂 Trying to figure how to make wheel well flanges with compound curves right now 🙁