Just another rattle can paint job, done in real time so that you know what it takes to get this done with good results. Products used inn this video are linked below for ease of purchasing. Thanks for supporting the channel.
2K Clear Coat (must have)
TSP (paint prep)
Primer
Duplicolor Paint
SandPaper
Frog Tape
3M Masking Paper
Likes: 4276
Views: 211362
It turned out good hector but when you shoot the paint you want to go in straight lines with a 30 to 50 % overlap you were spot spaying and also you should have sanded the whole panel i noticed that the paint stuck on the panel more were you sanded the same spot that you point were you needed more primer you did not sand or scuff that area but good job
Major helpful vid great presentation thank you
Wet sand that 2k and buff and polish and that shit glass!
Firme!
Nice job, looks great!
Bro why you no mask the wheels off? Besides that you did a great job
That overspray mess with your rim??
Hektor!!!!! .. Hektor!!!!!
Que lija estás usando? 400?
You needed a fourth coat or to go heavier on your third. You’re going to have to wet sand that a lot to make it look right.
You should cover the while and the bumper.