Rebel Editor August 17, 2018 50 Comments



2 Part Epoxy Glue is the best way to fix a cracked flexible bumper cover. or 972-420-1293

Likes: 1780

Views: 962790

Leave a Reply

  1. Dean Studer

    What I wanted to learn about was the characteristics of the specialty epoxy used. Was it flexible or not. Wouldn't use Bondo or fiberglass for the flexible bumper because the hard patches would prevent flexibility and they don't stick well. So in search of whats being used I found this first. None of this was discussed or tested after the fix. For me and certainly many more its the lower spoiler that hits parking lot cement bumpers. So this video disappointed me. Was not touched on and should been paramount. Not enough prep sanding anew mixed up a ton too much epoxy.Then when he revealed the wrong alignment of the surfaces, he copped an attitude and began cussing. I can handle it but it's not beneficial. Then not concise either, disclaimer repeated as if senile. I comment extremely rarely and give a thumbs down less often than that.

  2. Jim Stafford

    Hardly ready for paint. So sloppily done. Front crack so misaligned needs to be completely redone.

  3. crush smith

    i just weld them back together hope all the pieces are there if your missing a part you can cut from a worse one for a patch if your good you can fix them it like 10 minutes my last one fixed needed no filler just sanding prime prime and paint

  4. Karl James

    Grow up people use the f bomb as a form of communication

  5. Don’tGetScaredTV

    Is this SCOOBY? Where's HANS.

  6. jerry bushman

    The first thing you should do before making any bumper repair is to search for a new one. A simple search showed this bumper cover is only $55. It is a waste of time making any repair to this bumper that requires removal and or paint

  7. brian stuart

    didn't lineup that bottom up very well oh yeah smart guys you take a staple gun and you staple it and certain spots to hold everything straight then you apply your sit on the back side and then when you're done you go back to the front side and pull your staples

  8. brian stuart

    and now I'm showing you the professional way

  9. Kong Kali Kong Kong

    soma auta punya kai lao cakap..mcm kepala bapok punya video

  10. mark m

    I have a 99 Mustang in my bumper cover was cracked similarly only a whole lot more and I used a two heat range old soldering iron and stitched it together and then with a utility knife cut a piece of the plastic off the lower edge of the bumper use that as filler rod and kept working it and melted the whole thing together and on the outside it was just sand and paint

Comments are closed.